Showing results: 841 - 855 of 2628 items found.
-
NUL-202 -
Neulog
This sensor can be used to measure the current in parallel or series branches of low voltage AC and DC circuits and also to investigate the dependence of the current flow through components on the voltage across them.
-
LT45 -
Trailer Light Tester
The LT45 tester performs both light & electric brake function testing. It incorporates a digital display for checking voltage and current draw of tested circuit. This tester is powered by an internal battery.
-
MCL-3000D -
MULTI MEASURING INSTRUMENTS Co., Ltd.
This handy type clamp tester has the biggest CT window in the world (108mmx128mm) and can measure AC load current (0.01A -3000A) just by clamping the conductor without disconnecting the circuit.
-
Zero Defects International LLC
2D and 3D X-Ray Inspection services are available through the ZDI/Viscom applications center in San Jose. These services are especially valuable for failure analysis of failed or returned printed circuit assemblies.
-
K-280 -
The Eastern Specialty Company
TESCO Knopp’s K-280 Single Phase Socket Tester is designed to detect short circuits, backfeed and wiring errors in a 120/240 volt, 3-wire, single phase self-contained meter socket.
-
Picoprobe
The GGB Industries MULTI-CONTACT WEDGE allows for more chip design flexibility because it is custom configured to your circuit. Four Wedges can be used at the same time to probe a complete chip.
-
Chauvin Arnoux Metrix
Are designed for measuring leakage current diverted towards the earth. It enables the fault to be located or anticipated without disconnecting the equipment linked. It is specially designed to detect low fault currentson power circuits.
-
Coda Systems Ltd.
Low profile, short travel test probes for restricted space applicationsApplications where long travel is not required such as thin film/hybrid circuits or bareboard PCB testingReplaceable test probe by use of a receptacle
-
3662-5 -
VECTOR Electronics and Technology, Inc.
44 Gold plated edge contacts (22 each side)on 0.156"(3.96mm) centers.No circuit pattern edge contacts only. Unrestricted component placement over entire board surface
-
3662-2 -
VECTOR Electronics and Technology, Inc.
44 Gold plated edge contacts (22 each side)on 0.156"(3.96mm) centers.No circuit pattern edge contacts only. Unrestricted component placement over entire board surface
-
3797 -
VECTOR Electronics and Technology, Inc.
30 Gold plated edge contacts (15 each side)on 0.156"(3.96mm) centers.Convenient easy-to-read hole marking legend on both sides.No circuit pattern edge contacts only.
-
EM-6980 | 20 Hz – 50 KHz -
Electro-Metrics Corp.
Current probes enable you to measure conducted current without direct connection to the circuit under test by clamping around the conductor, current carrying wire or structural member being tested.
-
EM-6981 | 9 KHz – 110 MHz -
Electro-Metrics Corp.
Current probes enable you to measure conducted current without direct connection to the circuit under test by clamping around the conductor, current carrying wire or structural member being tested.
-
Amperis sl
The Rapidox SF6 6100 Pump Back is a fully-automatic zero-emissions SF6 gas analyser, designed for controlling and monitoring the quality and purity of gas used in high voltage switchgear, circuit breakers and transformers.
-
MRC ltd.
It is an electrical wiring device whose function is to disconnect the circuit when it detects currents leaking to the earth wire. It also gives protection against electric shock or electrocution caused by direct contacts.